Weaver Universal Dinghy Chocks provide a
solid, stable platform for storing inflatable and hard shelled dinghies on power
boat decks, docks or piers. They are made of 100% stainless steel with a molded
Hypalon pad for protecting the bottom of your dinghy.
Weaver Family of Dinghy Chocks
The variety of Weaver dinghy chocks range
from the standard model on the left to swivel chocks that range from 8" to
16" in height. Weaver Industries, Inc. now makes a series of custom dinghy
chocks and accessories designed to make even a complex installation simple. What
ever your chock need, Weaver has a solution!
C 1000
The C 1000 dinghy chocks are the perfect
installation for most hard bottom inflatable as well as hard shelled dinghies.
Made of 100% stainless steel and molded Hypalon, the C 1000 are built to last
and come with the Weaver Lifetime Manufacturers guarantee.They are easy to install and will provide years
of service and protection for your dinghy.
C 1204 Universal Swivel Chocks
C 1204 Weaver Universal Swivel Chocks are
designed to pivot and fit to the bottom of hard shelled dinghies and inflatables
with hard bottoms. The C 1204 chocks also work well with personal water craft
that weigh under 800 pounds.
CS Bolts With Spacers
As an added accessory, CS bolts, combined
with spacers, can gain from 1" to 4" in height. The CS Bolt Standard
Knuckle Joint, pictured at the right on the photograph at the left, is combined
with the CS Bolt and spacer to allow for pad movement in two directions. The
photo at the right show a C 1204 with a 4" spacer.
Custom Weaver Chocks
Weaver Industries, Inc. makes a series of
custom dinghy chocks designed to accommodate most situations. Custom Universal
Chocks are perfect for storing dinghies on areas where a normal chock would
restrict the opening of a hatch. Custom sizes can be made upon request to the
Weaver Industries factory.
C305 Pad (left) C 407 (right)
The C 305 is the standard size pad that is
normally shipped with chock sets. For boaters who need an oversize pad to take
the weight of a heavier dinghy, the C 407 is the solution. Both pads are made of
high grade molded Hypalon material and will not leave marks on your dinghy or
personal water craft.
Chock Measurements
The C 200 is the number used when ordering a
single chock from the C 1000 series of 4 chocks. It measures 6" to the
points outlined in the drawing. The CS 250 is a single chock of the C 1204
series of 4 chocks. It measures 6" to the point indicated in the drawing.
The footprint for both the C 200 and the CS 250 is 7" from base plate to
base plate and the plates themselves measure 5" in length.
